Remove machine from box and inspect for transit damage.
Select suitable location to mount machine.
Fasten to a bench using 4 holes in base plate. It should be mounted 27" from ground level. Generally this is a good working height.
Fit 2 piece extension handle together and slide over operating lever.
Select correct size die set and fit to machine. 1=20mm, 2=25mm, 3=32mm, 4=40mm, 5=50mm, 6=65mm (if supplied).
Fit male die to moving head with locating pin hole to rear and tighten bolt. Do not over tighten.
Fit female die to frame and adjust, by closing gap between male and female dies. Tighten bolt at front of machine, first checking that machine will operate. Then tighten bolt underneath. Do not over tighten.
Notcher is ready for use.
Any burrs will be concealed when welding is completed.
Spare parts and dies for RHS, ERW tube are also available.
Note: there is a gap in the dies at different points due to the arc that the dies travel through. This is normal and will not effect the operation of the machine.